Before.
After.
Remove the two screws that...
Remove the two screws that hold the grille on, and pull the entire assembly off. Dont just rip the thing out. Be gentle and make sure to remove the light bulbs as you pull it off.
Place your MIC grille over...
Place your MIC grille over the stock grille and then secure it from behind. Make sure that everything is centered.
Start with the middle bolt...
Start with the middle bolt and snug it down. Turn it over, take a good hard look, center it, and then continue with the next bolt.
Repeat steps 2 and 3 until...
Repeat steps 2 and 3 until the entire top part of the grille assembly is centered and bolted down.
Now its time to add...
Now its time to add the bottom part of the grille insert. See steps 2 through 4. Its pretty much the same thing. No, wait a sec
its exactly the same thing.
After you have made sure that...
After you have made sure that everything is perfectly centered and secure, you may rip off the protective layer of masking tape (see helpful hints), and proceed to reinstall the grille assembly to the truck.
As you reinstall the grille,...
As you reinstall the grille, make sure that you put the light bulbs back into their special spot. You dont want to smash your bulbs while pressing the grille back in because that would suck.
When lining up everything,...
When lining up everything, be sure that all the fasteners snap back into place.
Screw in your screws. They...
Screw in your screws. They fit in the factory location.
Wipe all your greasy fingerprints...
Wipe all your greasy fingerprints off the beautiful stainless steel finish and take a look at your perfectly centered, brand-new, kick-ass MIC grille. By the way, your burrito is still thawing.
The Problem: Stock appearance, minimal coinage, and a 10-minute attention span. The Solution: We went to Master Image Customs (MIC) and asked them to give an S-10 a little front-end flare. For $199, they hooked us up with a totally awesome Fast Flame stainless steel grille insert. There is no cutting required, and the grille will make your ride look bad-ass without restricting airflow or deflating your wallet.
Master Image Customs offers the grille inserts in three different styles that are available for most vehicles: Fast Flame (featured), Tiki Tribal, and Super Star. Even if you classify yourself as a top-rate dumb-nut, we have a feeling youll find the installation painfully simple. Well even throw in some helpful hints and a list of grille installation no-nos.
The Prep
Go throw a celebratory burrito in the microwave. It will be ready by the time youre done with the installation. Trust us. Its that easy.